I didn t use it but a kicker is recommended.
Installing pre padded carpet on stairs.
Next step is to apply the carpet padding to each step using the hammer stapler.
1 remove the old tackless strips with a pry bar if you plan to replace the old carpet.
Https amzn to 2ukunce so the big question is how is it holding up especially since i did not use a kicker o.
Carpet on stairs can cushion the descent down the flight and cut back on the racket when kids pets or guests ascend the staircase to the second floor.
Prepare your stairs for carpet installation by installing tack.
A well done stair runner installation can greatly improve the look of the staircase as well as improve the safety of the structure.
Install carpet padding in pieces to fit over the top of each stair tread.
Take care to place your staples roughly six inches from one another.
Step 3 begin attaching your carpet pad.
You may now begin attaching your freshly cut strips of padding to each individual stair.
Trim the pad where the nosing and the top of the riser meet.
Probably the biggest mistakes that happens when installing carpeting on stairs is the appearance of seams and a carpet not stretched tightly enough.
Start this step by using your staple gun to attach your padding to the tackless strips you placed on each your stairs back verticals.
Step 4 pull the other half of the carpet back and remove the paper from the tape on that half of the room.
Once you have selected your carpet measured and prepped your stairs you are ready to begin installing your new carpet before getting started be sure to learn the terms for the different parts of your staircase.
When stapling be sure to set the staples deep in the carpet webbing or else they might be visible.
Installing carpet on stairs can be tricky and time consuming but it can be accomplished even by novices with some understanding and patience.
Pre hemmed runners are usually sold in one of a few widths.
Installing carpet on stairs the right way.
Now that you have a clean surface it is time to install.
If your carpet tack strips are in good condition then you can go ahead and install your pre cut carpet.
A pad can help the overlying carpet to last longer.
Push wrinkles out from the center of the room and walk across the installed side to push the carpet pad securely into the adhesive tape.