1 in general does well laid level clean and old vinyl flooring provide a moisture barrier.
Im ripoing up vinyl floor.
Dated worn or torn vinyl flooring cannot easily or effectively be repaired.
How to repair vinyl flooring.
The best way to tear out vinyl flooring is to pull up the vinyl and then go back and remove the remaining glue and pieces of flooring.
Scrape away the linoleum or vinyl and glue with a wide putty knife utility knife brick chisel paint scraper hammer or a bully flooring scraper.
Cut out the subfloor and linoleum or vinyl flooring as one piece.
For how to remove vinyl tile start by scoring the vinyl photo 1.
A good flooring to install over an existing floor is rigid vinyl core.
For sheet flooring or rolled flooring or vinyl flooring tiles that are larger than 2x2 feet square you will want to score the flooring into 12 inch strips to make it easier to handle and pull up.
Both wood plastic composite and stone plastic composite have a thick rigid core that will hide any imperfections in the subfloor.
4 can i install rigid.
If your flooring has suffered from water damage.
2 why cannot laminate be installed over vinyl tiles that have been glued.
Remove any adhesive on the subfloor.
Push vinyl floor adhesive under the edge of the rip using a putty knife.
Pull up the damaged section of vinyl flooring.
Often the best way to deal with this is to replace it with another floor covering in many cases it is easiest simply to leave the vinyl flooring in place and to install the new floor covering over it.
If the vinyl is glued you have two options.
3 in the latter case instead of pulling up the vinyl tiles a major messy piece of work can i put plastic then foam underlayment and then laminate.
How to remove linoleum or vinyl flooring with plywood subfloor.
Take up peeling flooring to allow the surface of the subfloor to dry out.
4 cover the rip with blue painter s tape and cover the repaired area with a brick heavy enough to hold the repair in place.
Cut a repair patch the same size as the hole from a scrap of vinyl flooring.
Sometimes your vinyl flooring can suffer from small cuts or cracks due to normal wear and tear and can even peel up at the corners if the adhesive becomes dry.
Remove any excess glue from the floor using the solvent recommended on the adhesive container.
It is easy to install over many types of existing floors including ceramic with grout lines.
Apply vinyl flooring adhesive to the subfloor.
Place the vinyl flooring patch in the hole.
Then turn it on and let er rip photo 2.
Next adjust the angle on the floor scraper until it pulls up vinyl without gouging the subfloor.